Skip to content
Design Smart

Room Notes

How to Descale a Coffee Machine: Step-by-Step Guide

Limescale slows your coffee machine and dulls the taste. Here's how to descale properly, rinse it clear and fix the common mistakes.

Black pod coffee maker with glass mug and beans

The short answer

Descaling dissolves the limescale that hot water leaves behind inside your machine's boiler, pipework and shower screen. Left alone, that chalky layer narrows the waterways, makes the pump work harder and leaves every cup tasting flatter and cooler.

The short version: empty the water tank, mix a descaler with fresh cold water at the dose your manual gives, run it through the machine on the descale setting (or in batches if there isn't one), then rinse with clean water until the water runs clear and tastes of nothing at all. Set aside an hour or so, most of it spent waiting and rinsing rather than doing anything.

How often does a coffee machine need descaling?

The machine will usually tell you: most modern models count litres and flash a descale warning before the scale gets serious. Don't wait for that if you notice any of these:

  • Water or coffee trickling out more slowly than it used to
  • Steam that is weak, sputtering or wet
  • A noisier, rattlier pump
  • Coffee that comes out lukewarm
  • White crust around the steam wand, spout or the inside of the tank
  • A machine that cuts out or beeps partway through a drink
Soft water area
Roughly every three to six months, or when the machine prompts
Average hardness
Roughly every two to three months
Hard water area
Every four to eight weeks, and a water filter is worth considering
Heavy daily use
Sooner than the calendar suggests — more litres means more scale
Always
The interval in your manual and the machine's own prompt take priority over any rule of thumb

What you need before you start

Descaler
The one named in your manual, or food-grade citric acid — never mix two products together
Fresh cold water
Enough for the descale cycle plus two or three full rinsing tanks
A jug or deep bowl
Wide enough to sit under the spout and deep enough not to overflow
Warm soapy water and a soft cloth
For the tank, drip tray, steam wand and carafe afterwards
Your manual
The dose, cycle length, filter removal and reset steps are all machine-specific
Time
Around an hour, most of it waiting and rinsing

You don't need anything specialist beyond the machine's own parts and a jug. Work near a sink, clear the worktop so you have somewhere to put a wet tank down, and keep the room ventilated.

Which descaler to use

Machine makers usually specify either their own descaler or a citric-acid-based one. Where the manual names a product, use it: the dose, cycle length and rinse steps are written around it, and some warranties are conditional on using an approved descaler. Food-grade citric acid powder is the usual alternative in simple machines, mixed to the strength your manual states.

Descalers are not interchangeable — what suits one machine can damage another.
DescalerGood forWatch out for
Manufacturer's liquid or tablet descalerThe safest choice — formulated for that machine and usually the product named in the manualDose and cycle length vary between makers, so follow those instructions exactly
Food-grade citric acid powderEffective on limescale and rinses out cleanlyStrength varies with how you mix it, and long contact can affect some metals and seals — check the manual first
White vinegarShifts light scale in simple machinesThe smell lingers, and acetic acid can damage aluminium and rubber parts; many manuals rule it out entirely

Descaling a bean-to-cup or espresso machine

  1. 01 /

    Read the descale section of your manual

    Note the dose, the length of the cycle, whether a water filter has to come out and how the descale light is reset. These differ enough between machines that guessing usually costs you a wasted cycle.

  2. 02 /

    Empty and rinse the water tank

    Tip out any standing water, wash the tank in warm soapy water, rinse it and dry the outside. If there is a filter cartridge in the tank or on the water line, remove it — descaling solution ruins filter cartridges.

  3. 03 /

    Mix the descaler at the stated dose

    Use fresh cold water, never hot, and stir until the powder or liquid is fully dissolved. Stronger is not better: an over-strong mix is harder to rinse out and puts more stress on seals.

  4. 04 /

    Set up for the run

    Put a jug under the coffee spout and another under the hot water or steam outlet if the cycle uses them. Remove the portafilter, empty the drip tray, and make sure there's no milk in the machine or its carafe.

  5. 05 /

    Start the programme, or run it in batches

    If there is a descale programme, start it and let the machine do the pumping. If not, run a cup at a time into the jug, pause for a few minutes, and repeat until the tank is empty — finishing with a burst through the hot water spout so the whole circuit sees the descaler.

  6. 06 /

    Let it dwell, but not for hours

    Many programmes pause partway through to give the descaler time to work. Follow that timing rather than extending it. Leaving solution sitting in the machine overnight is what damages seals and metal parts.

  7. 07 /

    Rinse the tank and run clean water through

    Wash the tank thoroughly, fill it with fresh cold water and run the rinse cycle. Repeat with clean water until the machine stops asking and the water runs clear and odourless.

  8. 08 /

    Finish, reset and refit

    Refit the water filter — a new one if the old one was in place during descaling — refill the tank and run one short rinse through the group. Make a coffee and pour it away before you drink the next one.

Descaling a filter or drip machine

  1. 01 /

    Clear the machine out

    Bin the paper filter and any ground coffee, empty the carafe, and take off the lid and filter basket so you can wash them separately later.

  2. 02 /

    Mix the solution in the reservoir

    Fill to the mark your manual gives with fresh cold water and the stated dose of descaler, stirring gently so it dissolves.

  3. 03 /

    Run about half of it through

    Set the empty carafe under the basket, switch on and let roughly half the tank run through. Switch off before it empties.

  4. 04 /

    Let it sit and work

    Leave the machine switched off for the time the manual recommends — often 15 to 30 minutes — so the descaler can dissolve the scale in the hot plate, tube and shower head.

  5. 05 /

    Run the rest through

    Switch back on and let the remaining solution pass through into the carafe, then tip it away down the sink.

  6. 06 /

    Rinse two or three times

    Fill the reservoir with fresh cold water and run a full tank through, discarding it. Repeat at least twice, until the water smells and tastes of nothing.

  7. 07 /

    Wash the parts

    Wash the carafe, lid and filter basket in warm soapy water, rinse well and dry before reassembling. Wipe the outside with a damp cloth — never dunk the base in water.

Rinsing properly

Almost every complaint about descaling — a sour edge to the coffee, a lingering chemical smell, a machine that still beeps — comes down to an incomplete rinse. The machine's own rinse count is a minimum, not a guarantee.

Use a clean tank, not the one you mixed the solution in. Run fresh water through the whole circuit, including the hot water spout and steam wand, and discard every jugful rather than recycling it. Then taste the water coming out: it should be neutral, with no sharpness and no smell.

When descaling goes wrong

The descale light stays on
Some machines only clear it when the full programme including the rinse finishes; others need a manual reset in the menu. Check the manual before running a second cycle.
Water still flows slowly
Heavy scale may need a second cycle a day later. If flow doesn't return after that, stop and have the machine looked at.
Coffee tastes sour or chemical
Incomplete rinse. Run two or three full tanks of fresh water through and discard each one.
The machine stops partway through
Usually a full drip tray or an empty tank. Empty or refill, then restart the programme from the beginning.
Water appears under the machine
Check the tank is seated squarely, the seals are clean and you haven't overfilled it. If water reaches the electrics, unplug and stop.
Nothing comes out at all
Don't keep adding descaler. A blocked pump, stuck valve or failed filter needs a service, not another cycle.

Safety and things that are easy to get wrong

Descaling solution is an acid. Treat it like one:

  • Never drink it, and never run a coffee through while the machine is descaling
  • Keep children and pets out of the room while the machine is open and running
  • Don't leave solution in the tank, boiler or carafe for hours, and don't store a mixed batch for next time
  • Don't put descaler anywhere near the bean hopper, the brew group or the milk system
  • Use cold water — hot water makes the solution more aggressive and can damage parts
  • Unplug the machine before wiping it down, and never immerse the base
  • Don't scrape scale off with a knife, wire wool or anything abrasive; dissolve it instead
  • Wash your hands after handling powder or liquid descaler, and ventilate the kitchen

Keeping limescale down between descales

Scale builds up faster when water sits around warm. Empty the tank at the end of the day rather than leaving it full for a week, and refill with fresh cold water each time. If your machine accepts a water filter cartridge, use one and change it on schedule — it won't stop scale, but it slows it considerably.

Wipe the steam wand straight after every use and give the drip tray a rinse, so you're not confusing milk and coffee residue with scale. In very hard water areas, filtered water for the machine is the single change that makes the biggest difference to how often you have to do this job.

Common questions about descaling

Can I use lemon juice instead of a descaler?

Lemon juice is mostly citric acid, so it will shift some scale, but the strength varies from bottle to bottle and the pulp and sugars leave a residue in the tank and pipework. Food-grade citric acid powder or a proper descaler gives you a dose you can actually measure.

Will descaling fix a machine that has stopped pumping water?

Not always. If a full cycle and a thorough rinse don't restore flow, the problem may be a failed pump, a stuck valve or a blocked filter, which needs servicing rather than more descaler.

How do I clear the descale light?

Most machines clear it automatically when the whole programme, rinse included, has finished. Others need a button held down or a confirmation in the menu; the exact sequence is in your manual.

Do I still need to descale if I only use filtered or bottled water?

Yes, just less often. Filtered water carries fewer minerals but not none, and some bottled mineral waters are high in calcium.

Can I descale the milk frother with the same solution?

No. Descaler targets mineral scale, while milk residue is fat and protein. Use a dairy cleaner or warm soapy water for the frother, and keep descaler away from anything that touches milk.

Search