Skip to content
Design Smart

Room Notes

How to Clean a Dishwasher: Step-by-Step Guide

A practical, step-by-step guide to cleaning a dishwasher: the filter, spray arms, door seal and tub, plus descaling and the mistakes to avoid.

Gloved hands washing dishes in sink with cleaning bottles

The short answer

A dishwasher washes itself while it washes your plates — up to a point. Food scraps, grease and limescale gather in the filter, the spray arm jets, the door seal and the base of the tub, and that build-up is what causes the smell, the cloudy glasses and the gritty film on cutlery.

The short version: once a month, empty the machine, switch it off at the wall, rinse the filter under the tap, poke the spray arm holes clear, wipe round the door seal, then run the hottest empty cycle with a cup of white vinegar or a spoonful of citric acid in the tub. Leave the door ajar afterwards so it dries out.

If your machine already smells, or the glasses come out cloudy, treat the first clean as a deep clean: descale as well, and clean the filter weekly for a month until things settle down.

What you need before you start

Nothing here is specialist kit, and most of it is already under the sink:

  • Washing-up liquid and a soft brush or an old toothbrush
  • A microfibre cloth and a dry tea towel
  • White vinegar or citric acid
  • Bicarbonate of soda for stains and grease film
  • A cocktail stick or straightened paper clip for the spray arm holes
  • Rubber gloves if the filter turns your stomach
  • The machine's manual, if you still have it

Give yourself twenty minutes of hands-on time plus one full cycle, and do it when you don't need the machine for a couple of hours.

White vinegar
About 250 ml in a heatproof cup on the top rack for the cleaning cycle
Citric acid
A spoonful in the tub, or the dose on the descaler label if you use one
Bicarbonate of soda
Two to three tablespoons made into a paste for marks and grease film
Programme
The hottest, longest cycle the machine offers, run empty
Hands-on time
Around 20 minutes, plus the cycle and drying time

How to clean a dishwasher, step by step

  1. 01 /

    Empty it and switch it off

    Take out every dish, the cutlery basket and any racks that lift out easily. Switch the machine off at the wall socket — you're about to put your hands inside it.

  2. 02 /

    Lift out and rinse the filter

    The filter sits at the bottom of the tub, usually in two or three parts. Twist or lift it out, rinse under warm running water and scrub it with a soft brush and a drop of washing-up liquid. Hold it up to the light: if you can still see grease or grit in the mesh, keep going.

  3. 03 /

    Clear the spray arm holes

    Unclip the spray arms if your model allows it, then poke each hole clear with a cocktail stick. Rinse them through, check they spin freely, and refit them the right way up.

  4. 04 /

    Wipe round the door seal

    Run a damp cloth right round the gasket, lifting the folds as you go. Food and black mould collect in the creases at the bottom corners more than anywhere else. Dry it with a tea towel afterwards.

  5. 05 /

    Wipe the tub, the door and the edges

    Wipe the walls, the floor of the tub and the inside of the door with a damp cloth. For grey marks or a grease film, make a paste with bicarbonate of soda and a little water, work it in with the brush, then rinse it away.

  6. 06 /

    Refit everything properly

    Filter first, then spray arms, then racks. The filter has to click or twist fully home — a loose filter lets food through to the pump and is the most common reason a machine still smells after a clean.

  7. 07 /

    Run a hot empty cycle

    Put about 250 ml of white vinegar in a heatproof cup on the top rack, or a spoonful of citric acid straight into the tub, and run the hottest, longest programme with no dishes in it. Never add washing-up liquid — it foams and can trip the flood protection.

  8. 08 /

    Dry it out

    When the cycle finishes, wipe any standing water from the floor of the tub, leave the door slightly open and let it air. A closed, damp dishwasher is exactly where the smell comes back from.

If it still smells after a clean

Work through these before you assume the machine is broken:

  • The filter seating. Take it out and refit it, checking that every part locks into the one below.
  • The sump under the filter. Shine a torch into the recess and fish out any trapped food, labels or glass with a spoon — never with your fingers.
  • The door seal folds. Run a fingernail along the crease at the bottom corners; that's where mould hides.
  • Standing water in the base. If water sits in the bottom between cycles, the drain hose may be kinked or partly blocked, which is a job for an engineer rather than a cloth.
  • The salt level. In a hard-water area, a machine with an empty salt reservoir scales up faster, and scale holds on to smells.

How often to clean each part

Adjust these to your manual and to how often you run the machine.
PartHow oftenWhat to do
FilterMonthly, and any time it smellsLift out, rinse under warm water, scrub with a soft brush and a drop of washing-up liquid, refit fully home
Spray armsEvery one to two monthsUnclip, poke the holes clear with a cocktail stick, rinse through and refit
Door sealMonthlyWipe round every fold with a damp cloth, dry it, and check for food debris or black spots
Tub and inner doorMonthlyWipe the walls and floor, treat marks with bicarbonate of soda, then run a hot empty cycle
DescalingEvery three to six months in hard waterRun the hottest cycle with citric acid or a descaler, then a second rinse cycle
Salt reservoirWhen the indicator asksTop up with dishwasher salt; this is what keeps scale down in hard water

Descaling when you live in a hard-water area

Scale shows up as a white, chalky film on the inside of the door and around the heating element, and as glasses that come out cloudy even though they're clean. It builds fastest in hard-water areas and in machines that rarely run above 50 °C.

To descale, put citric acid or a descaler in the tub as the label directs and run the hottest empty cycle. Then run a second short rinse cycle to clear the residue, and wipe the tub dry. Don't combine a descaler with vinegar in the same cycle, and don't run a descaler with dishes inside.

What commonly goes wrong

  • The machine is left damp. Drying with the door shut undoes most of the good work. Leave it ajar after every cycle, not just cleaning day.
  • The filter goes back in wet and loose. Rinse it again if you drop it, and check the twist or click every time.
  • Too much vinegar. Half a bottle neat won't clean better than a cup; it just sits on the seals. Keep to the dose and use it occasionally.
  • Washing-up liquid in the tub. It foams, leaks out of the door and can trigger an error code. Clean the suds with a wet cloth and run a rinse cycle.
  • Scouring pads on stainless steel. They leave scratch marks that trap grease. Use a cloth or a soft brush.
  • Cleaning the machine with dishes inside. The residue you've loosened ends up on the plates. Always run the cleaning cycle empty.

Safety and things that damage the machine

A few more rules worth sticking to:

  • Switch off at the wall before reaching inside, and keep the plug and socket away from splashes.
  • Don't put knives point-up in the cutlery basket while you're working around it.
  • Keep detergent, salt and descaler out of reach of children, and don't let anyone help with the cleaning cycle.
  • Don't use abrasive powders or wire wool on the inner door or the tub.
  • If you see a puddle under the machine or the electrics trip, stop and get it looked at rather than running another cycle.

Keeping it fresher between deep cleans

Most of the difference is made by small habits rather than by cleaning products:

  • Scrape plates into the bin rather than rinsing them under the tap — the machine handles the rest, and less rinsing means less water down the drain.
  • Run the hottest programme once a week or so, especially in summer.
  • Leave the door ajar between cycles so the interior dries.
  • Wipe the door seal with the cloth you use for the worktops, once a week, in about ten seconds.
  • Check the filter whenever you notice a smell, rather than waiting for the next scheduled clean.

Frequently asked questions

Can I use bleach to get rid of a dishwasher smell?

No. Bleach attacks stainless steel and rubber seals, and mixing it with an acidic cleaner such as vinegar or citric acid produces chlorine gas. Use a hot cycle with vinegar or citric acid instead.

Can I clean the dishwasher with washing-up liquid?

A drop on the filter is fine, but never put it in the tub or the detergent drawer for a cycle. It foams heavily, can leak from the door and may trigger a flood error.

Why do my glasses come out cloudy even after a clean?

Cloudiness is usually limescale, not dirt. Descale the machine and check the salt reservoir; if the glasses are permanently etched, that damage can't be reversed.

Do I need to take the spray arms off to clean them?

Only if your model lets you unclip them easily. If they're fixed, poke the visible holes clear with a cocktail stick, run a hot cycle and check the arms still spin.

Is a dishwasher cleaner better than vinegar?

Both work. Vinegar and citric acid are cheap and effective for light build-up; a dedicated cleaner is worth it if your manual warns against vinegar or the machine is heavily scaled.

Search